Document Type : Research Articles

Author

Faculty of Engineering, University of Garmsar, Garmsar, Iran

Abstract

This paper presents an optimized microwave rectifier circuit that integrates various couplers to enhance RF-to-DC conversion efficiency. A comprehensive theoretical analysis and performance evaluation of different microwave couplers are conducted to determine their impact on power distribution and impedance matching. The study demonstrates that incorporating couplers into the rectifier circuit effectively reduces reflected power over a broad input power range. Among the evaluated configurations, the rectifier incorporating a branch-line coupler (BLC) exhibits superior RF-to-DC efficiency over a wide range of operating frequencies, input power levels, and output loads, ensuring broad impedance matching. To validate the proposed design, a rectifier circuit based on the BLC is implemented and fabricated at 2.45 GHz. The prototype consists of two identical sub-rectifying networks connected to the two output ports of the coupler, with the isolated port grounded. Experimental results indicate that the rectifier consistently achieves efficiency levels exceeding 50% for input power levels ranging from 0 to 12.5 dBm. Additionally, the design maintains high efficiency across a frequency range of 2.16 to 2.96 GHz. These findings underscore the potential of BLC-based rectifiers for high-efficiency microwave power transmission systems, offering enhanced energy harvesting capabilities and improved system performance.

Keywords

Main Subjects

[1] F. Geran, N. Mirzababaee, and S. Mohanna, "RF power harvester using a broadband monopole antenna and a quadband rectifier," International Journal of Industrial Electronics Control and Optimization, vol. 4, no. 1, pp. 59-65, 2021.

[2] H. Xiong, Q. Yang, Y.-Z. Huang, X. Wang, Z. Yi, and H.-Q. Zhang, "A high-efficiency hybrid microwave power receiving metasurface array with dual matching of surface impedance and phase gradient," Applied Physics Letters, vol. 125, no. 4, 2024.

[3] M. M. Fakharian, "A dual circular and linear polarized rectenna for RF energy harvesting at 0.9 and 1.8 GHz GSM bands," Electromagnetics, vol. 41, no. 8, pp. 545-556, 2021.

[4] M. M. Fakharian, "A wideband rectenna using high gain fractal planar monopole antenna array for RF energy scavenging," International Journal of Antennas and Propagation, vol. 2020, pp. 1-10, 2020.

[5] M. M. Fakharian, "A wideband fractal planar monopole antenna with a thin slot on radiating stub for radio frequency energy harvesting applications," International Journal of Engineering, vol. 33, no. 11, pp. 2181- 2187, 2020.

[6] J. Alirio and B. C. Nuno, "A batteryless RFID remote control system," IEEE Transactions on Microwave Theory and Techniques, vol. 61, no. 7, pp. 2727-2736, 2013.

[7] J. Guo, H. Zhang, and X. Zhu, "Theoretical analysis of RFDC conversion efficiency for class-F rectifiers," IEEE Transactions on Microwave Theory and Techniques, vol. 62, no. 4, pp. 977-985, 2014.

[8] S. Ladan and K. Wu, "Nonlinear modeling and harmonic recycling of millimeter-wave rectifier circuit," IEEE Transactions on Microwave Theory and Techniques, vol. 63, no. 3, pp. 937-944, 2015.

[9] M. Roberg, T. Reveyrand, I. Ramos, E.A. Falkenstein, and Z. Popović, "High-efficiency harmonically terminated diode and transistor rectifiers," IEE IEEE Transactions on Microwave Theory and Techniques, vol. 60, no. 12, pp. 4043-4052, 2012.

[10] C. Wang, N. Shinohara, and T. Mitani, "Study on 5.8-GHz single-stage charge pump rectifier for internal wireless system of satellite," IEEE Transactions on Microwave Theory and Techniques, vol. 65, no. 4, pp. 1058-1065, 2017.

[11] Q. Zhang, J-H. Ou, Z. Wu, and H-Z. Tan, "Novel microwave rectifier optimizing method and its application in rectenna designs," IEEE Access, vol. 6, pp. 53557-53565, 2018.

[12] H. Zeng, Y. Tang, and Y. Liu, "Compact high-efficiency cband rectifier with high input power for microwave power transmission," Electronics Letters, vol. 59. e12776, 2023.

[13] H. Xiao, H. Zhang, W. Song, J. Wang, W. Chen, and M. Lu, "A High-Input Power Rectifier Circuit for 2.45-GHz Microwave Wireless Power Transmission," IEEE Transactions on Industrial Electronics, vol. 69, no. 3, pp. 2896-2903, March 2022.

[14] J. Kimionis, A. Collado, M.M. Tentzeris, and A. Georgiadis, "Octave and decade printed UWB rectifiers based on nonuniform transmission lines for energy harvesting," IEEE Transactions on Microwave Theory and Techniques, vol. 65, no. 11, pp. 4326-4334, 2017.

[15] M. Mansour, X.L. Polozec, and H. Kanaya, "Enhanced broadband RF differential rectifier integrated with archimedean spiral antenna for wireless energy harvesting applications," Sensors, vol. 19, no. 3, pp. 1-13, 2019.

[16] M. Nariman, F. Shirinfar, S. Pamarti, A. Rofougaran, and F.D. Flaviis, "High-efficiency millimeter-wave energyharvesting systems with milliwatt-level output power,"IEEE Transactions on Circuits and Systems II, vol. 64, no. 6, pp. 605-609, 2017.

[17] Y. L. Lin, X. Y. Zhang, Z.-X. Du, and Q. W. Lin, "Highefficiency microwave rectifier with extended operating bandwidth," IEEE Transactions on Circuits and Systems II, vol. 65, no. 7, pp. 819-823, 2017.

[18] J. Liu, X. Y. Zhang, and C. L. Yang, "Analysis and design of dual-band rectifier using novel matching network," IEEE Transactions on Circuits and Systems II, vol. 65, no. 2, pp. 431-435, 2018.

[19] M. M. Fakharian, "A compact UWB antenna with dynamically switchable band-notched characteristic using broadband rectenna and DC-DC booster," International Journal of Microwave and Wireless Technologies, vol. 13, no. 10, pp. 1086-1095, 2021.

[20] Y. Huang, N. Shinohara, and T. Mitani, "A constant efficiency of rectifying circuit in an extremely wide load range," IEEE Transactions on Microwave Theory and Techniques vol. 62, no. 4, pp. 986-993, 2014.

[21] Y. Lu, H. J. Dai, M. Huang, M.-K. Law, S.-W. Sin, S.-P. U, and R.P. Martins, "A wide input range dual-path CMOS rectifier for RF energy harvesting," IEEE Transactions on Circuits and Systems II, vol. 64, no. 2, pp. 166-170, 2017.

[22] T. W. Barton, J. Gordonson, and D. J. Perreault, "Transmission line resistance compression networks and applications to wireless power transfer," IEEE Journal of Emerging and Selected Topics in Power Electronics, vol. 3, no. 1, pp. 252-260, 2015.

[23] S. H. Abdelhalem, P.S. Gudem, and L.E. Larson, "An RFdc converter with wide-dynamic-range input matching for power recovery applications," IEEE Transactions on Circuits and Systems II, Express. Briefs, vol. 60, no. 6, pp. 336-340. 2013.

[24] X. Y. Zhang and Q.-W. Lin, "High-efficiency rectifier with extended input power range based on two parallel subrectifying circuits," IEEE International Wireless Symposium, Shenzhen, China, Match 2015, pp. 1-4.

[25] Z.-X. Du and X. Y. Zhang, "High-efficiency microwave rectifier with less sensitivity to input power variation," IEEE Microwave and Wireless Components Letters, vol. 27, no. 11, pp. 1001-1003, 2017.

[26] Y. Y. Xiao, Z.-X. Du, and X. Y. Zhang, "High-efficiency rectifier with wide input power range based on power recycling," IEEE Transactions on Circuits and Systems II: Express. Briefs, vol. 65, no. 6, pp. 744-748, 2018.

[27] X. Y. Zhang, Z.-X. Du, and Q. Xue, "High-efficiency broadband rectifier with wide ranges of input power and output load based on branch-line coupler," IEEE Transactions on Circuits and Systems I: Reg. Papers, vol. 64, no. 3, pp. 731-739, 2016.

[28] M. Huang, Y. L. Lin, J.-H. Ou, X. Y. Zhang, Q. W. Lin, W. Che, and Q. Xue, "Single- and dual-band RF rectifiers with extended input power range using automatic impedance transforming," IEEE Transactions on Microwave Theory and Techniques, vol. 67, no. 5, pp. 1974-1984, 2019.

[29] K. Niotaki, A. Georgiadis, A. Collado, and J. S. Vardakas, "Dual-band resistance compression networks for improved rectifier performance," IEEE Transactions on Microwave Theory and Techniques, vol. 62, no. 12, pp. 3512-3521, 2014.

[30] M. M. Fakharian, "A high gain wideband circularly polarized rectenna with wide ranges of input power and output load," International Journal of Electronics, vol. 109, no. 1, pp. 83-99, 2021.

[31] V. Marian, C. Vollaire, J. Verdier, and B. Allard, "Potentials of an adaptive rectenna circuit," IEEE Antennas and Wireless Propagation Letters, vol. 10, pp. 1393-1396, 2011.

[32] C. J. Li and T. C. Lee, "2.4-GHz high-efficiency adaptive power harvester," IEEE Transactions on Very Large Scale Integration Systems, vol. 22, no. 2, pp. 434-438, 2014.

[33] Z. Liu, Z. Zhong, and Y.-X. Guo, "Enhanced dual-band ambient RF energy harvesting with ultra-wide power range," IEEE Microwave and Wireless Components Letters, vol. 25, no. 9, pp. 630-632, 2015.

[34] Z. Du, S. F. Bo, Y. F. Cao, J. Ou, and X. Y. Zhang, "Broadband circularly polarized rectenna with wide dynamic-power-range for efficient wireless power transfer," IEEE Access, vol. 8, pp. 80561-80571, 2020.

[35] M. M. Fakharian, "RF energy harvesting using high impedance asymmetric antenna array without impedance matching network," Radio Science, vol. 56, no. 3, pp. 1-10, 2021.

[36] C. Peng, Z. Ye, J. Wu, C. Chen, and Z. Wang, "Design of a wide-dynamic RF-DC Rectifier circuit based on an unequal wilkinson power divider," Electronics, vol. 10, p. 2815, 2021

[37] V. Marian, B. Allard, C. Vollaire, and J. Verdier, "Strategy for microwave energy harvesting from ambient field or a feeding source," IEEE Transactions on Power Electronics, vol. 27, no. 11, pp. 4481-4491, 2012.

[38] Non RF applications for surface mount schottky diode pairs HSMS2850, Datasheet, Avago Technol., San Jose, CA, USA, May 2010.

[39] D. M. Pozar, Microwave engineering, 4th edition. New York, NY, USA: Wiley, 2012.

[40] J. Huang, Y. Zhou, Z. Ning, and H. Gharavi, "Wireless Power transfer and energy harvesting: current status and future prospects," IEEE Wireless Communications; vol. 26, no. 4, pp. 1-7, 2019.

[41] X. Zhu, K. Jin, Q. Hui, W. Gong, and D. Mao, "Long-range wireless microwave power transmission: a review of recent progress," IEEE Journal of Emerging and Selected Topics in Power Electronics, vol. 9, no. 4, pp. 4932-4946, 2021.

[42] N. Shinohara, Wireless power transfer via radiowaves. John Wiley & Sons, 2014.

[43] D. Kobuchi, G. E. Moore, Y. Narusue and J. R. Smith, "Suppression of receiver harmonic currents in wireless power transfer systems," IEEE Wireless Power Technology Conference and Expo, San Diego, USA, 2023, pp. 1-5.

[44] P. Lazzeroni, V. Cirimele, and A. Canova, "Economic and environmental sustainability of Dynamic Wireless Power Transfer for electric vehicles supporting reduction of local air pollutant emissions," Renewable and Sustainable Energy Reviews, vol. 138, pp. 1-15, March 2021.