Document Type : Research Articles

Authors

1 Department of Electrical Engineering, Shabestar Branch, Islamic Azad University, Shabestar, Iran

2 Islamic Azad University, shabestar Branch

3 Faculty of Electrical Engineering, Islamic Azad University, Shabestar Branch, Shabestar, Iran.

4 Department of Electrical Engineering, Ahar Branch, Islamic Azad University, Ahar, Iran

Abstract

This paper proposes an integrated bidirectional multiport DC-DC converter for battery charging of plug-in electric vehicles, which is able to integrate the photovoltaic (PV) system, traction batteries, and the AC grid. The presented converter is more reliable than the conventional topologies because both PV panels and the grid can simultaneously or separately deliver power to the high voltage batteries. In addition, the topology is bidirectional can transfer power from batteries to the AC grid by employing half-bridge CLLC converter with fewer switches. Moreover, a unified controller along with optimum maximum power point tracking (MPPT) algorithm is utilized for control of the converter. The converter topology, control system, and operating scenarios are analyzed by using state space modeling. To evaluate the whole system performance, MATLAB/Simulink software is used to test the converter’s operation during different conditions. The simulation results depict that the proposed converter is not only able to control the batteries charge and discharge according to the state of the charge, but also maintain the DC-link voltage of the grid side to be in constant level.

Keywords

Main Subjects

[1] Feizi M, Beiranvand R, Daneshfar M. An Integrated High Power Self-Equalized Battery Charger Using a Voltage Multiplier and Phase-Shifted Full-Bridge DC-DC Converter for Lithium-Ion Batteries. International Journal of Industrial Electronics Control and Optimization 2021; 4(2):141-155.
[2] Gonzalez A, Lopez-Erauskin R, Gyselinck J. Analysis, modeling, control and operation of an interleaved three-port boost converter for DMPPT systems including PV and storage at module level. Heliyon 2019; 5(3):1-31.
[3] Pan L, Zhang C. An Integrated Multifunctional Bidirectional AC/DC and DC/DC Converter for Electric Vehicles Applications. Energies 2016; 9(7):493.
[4] Ebadpour M, Sharifian M.B.B. Cascade H-Bridge Multilevel Inverter with Low Output Harmonics for Electric/Hybrid Electric Vehicle Applications. International Review of Electrical Engineering (IREE) 2012; 7(1): 3248-3256.
[5] Tu h, Feng H, Srdic S, Lukic S. Extreme Fast Charging of Electric Vehicles: A Technology Overview. In: IEEE Transactions on Transportation Electrification; 2019. IEEE; 2019. p. 861-878.
[6] Jyotheeswara Reddy K, Natarajan S. Energy sources and multi-input DC-DC converters used in hybrid electric vehicle applications – A review. International Journal of Hydrogen Energy 2018; 43(36):17387-17408.
[7] Yilmaz M, Krein PT. Review of battery charger topologies, charging power levels, and infrastructure for plug-in electric and hybrid vehicles. IEEE Trans Power Electron 2013; 28(5):2151-2169.
[8] Pellegrino G, Armando E, Guglielmi P. An Integral battery charger with power factor correction for electric scooter. IEEE Trans Power Electron 2010; 25(3):751-759.
[9] Zhu H, Zhang D, Zhang B, Zhou Z."A nonisolated threeport DC–DC converter and three-domain control method for PV-battery power systems. IEEE Trans Ind Electron 2015; 62(8):4937-4947.
[10] Wen G, Chen Y, Kang Y. A family of cost-efficient integrated single-switch three-port converters. In: TwentyEighth Annual IEEE Applied Power Electronics Conference and Exposition (APEC); 2013. IEEE; 2013. p. 1062-1067.
[11] Cheng T, Lu DDC, Gong A, Verstraete D. Analysis of a three-port DC-DC converter for PV-battery system using DISO boost and SISO buck converters. In: Australasian Universities Power Engineering Conference (AUPEC); 2015. IEEE; 2015. p. 1-6.
[12] Faraji R, Farzanehfard H. Soft-switched nonisolated high step-up three-port DC–DC converter for hybrid energy systems. IEEE Trans Power Electron 2018; 33(12):10101-10111.
[13] Kumar L, Jain S, A multiple source DC/DC converter topology. Int J Electron. Power Energy Syst 2013; 51:278-291
[14] Li W, Xiao J, Zhao Y, He X. PWM plus phase angle shift (PPAS) control scheme for combined multiport dc/dc converters. IEEE Trans Power Electron 2012; 27(3):1479–1489.
[15] Pinto JG, Monteiro V, Goncalves H, Afonso JL. On-board reconfigurable battery charger for electric vehicles with traction-to-auxiliary mode. IEEE Trans Veh Technol 2014; 63(3):1104–1116.
[16] Wu H, Sun K, Ding S, Xing Y. Topology derivation of nonisolated three-port dc-dc converters from DIC and DOC. IEEE Trans Power Electron 2013; 28(7):3297–3307.
[17] Taheri A, Asgari N. Sliding Mode Control of LLC Resonant DC-DC Converter for Wide output voltage Range in Battery Charging Applications. International Journal of Industrial Electronics Control and Optimization 2019; 2(2):127136.
[18] Chen Y-M, Liu Y-C, Wu F-Y. Multi-input DC/DC converter based on the multiwinding transformer for renewable energy applications. IEEE Trans Ind Appl 2002; 38(4):1096-1104.
[19] Wu H, Sun K, Chen R, Hu H, Xing Y. Full-bridge three-port converters with wide input voltage range for renewable power systems. IEEE Trans Power Electron 2012;27(9):3965-3974.
[20] Hu W, Wu H, Xing Y, Sun K. A full-bridge three-port converter for renewable energy application. In: IEEE Applied Power Electronics Conference and Exposition – APEC; 2014. IEEE; 2014. p. 57-62.
[21] Sun X, Shen Y, Li W, Wu H. A PWM and PFM hybrid modulated three-port converter for a standalone PV/battery power system. IEEE Journal of Emerging and Selected Topics in Power Electronics 2015; 3(4): 984-1000.
[22] Zhang J, Wu H, Qin X, Xing Y. PWM plus secondary-side phase-shift controlled soft-switching full-bridge three port converter for renewable power systems. IEEE Trans Ind Electron 2015;62(11):7061-7072.
[23] Tao H, Duarte JL, Hendrix MAM. Three-port triple-halfbridge bidirectional converter with zero-voltage switching. IEEE Trans Power Electron 2008; 23(2):782-792.
[24] Xu C et al. Performance analysis of coupled inductor based multiple-input DC/DC converter with PWM plus phase shift (PPS) control strategy. In: IEEE ECCE Asia Downunder; 2013. IEEE; 2013. p. 994-998.
[25] Zeng J, Qiao W, Qu L.A n isolated three-port bidirectional dc-dc converter for photovoltaic systems with energy storage. IEEE Trans Ind Appl 2015; 51(4):3493–3503.
[26] Soltani Gohari H, Abbasadeh K, Gholami Gorji J. A Controllable Bidirectional Rectifier for EV Home Charging Station with G2H/G2VH/V2H/V2G Functions. International Journal of Industrial Electronics Control and Optimization 2021; 4(1):99-113.
[27] Zhao B, Song Q, Liu W, Sun Y. Overview of dual-active bridge isolated bidirectional dc-dc converter for high frequency-link power-conversion system. IEEE Trans Power Electron 2014; 29(8):4091–4106.
[28] Jung J, Kim H, Ryu M, Baek J. Design methodology of bidirectional CLLC resonant converter for high-frequency isolation of dc distribution systems. IEEE Trans Ind Electron 2013; 28(4):1741–1755.
[29] Ebadpour M. A multiport isolated DC-DC converter for plug-in electric vehicles based on combination of photovoltaic systems and power grid. In: 12th Power Electronics, Drive Systems, and Technologies Conference (PEDSTC); 2021. IEEE; 2021. p. 1-5.
[30] Tang Y, Lu J, Wu B, Zou S, Ding W, Khaligh A. An integrated dual-output isolated converter for plug-in electric vehicles. IEEE Trans Veh Technol 2018; 67(2):966–976.
[31] Koutroulis E, Kalaitzakis K, Voulgaris NC. Development of a microcontroller-based, photovoltaic maximum power point tracking control system. IEEE Trans Power Electron 2001; 16(1):46-54.
[32] Li C, Chen Y, Zhou D, Liu J, Zeng J. A high-performance adaptive incremental conductance MPPT algorithm for photovoltaic systems. Energies 2016; 9(4):288.
[33] Mohanty S, Subudhi B, Ray PK. A grey wolf-assisted perturb & observe MPPT algorithm for a PV system. IEEE 
Trans Energy Convers 2017; 32(1):340-347.