Communication
Mozhgan Ehsani; Mehdi Bekrani; Solyman Garousi
Abstract
The delay-and-sum (DS) beamforming and delay-weight-and-sum (DWS) beamforming are primary methods in ultrasonic imaging with phased arrays. Total focusing method (TFM) and Minimum Variance (MV) based adaptive beamforming are well-known methods within DS and DWS beamforming, respectively. The MV-based ...
Read More
The delay-and-sum (DS) beamforming and delay-weight-and-sum (DWS) beamforming are primary methods in ultrasonic imaging with phased arrays. Total focusing method (TFM) and Minimum Variance (MV) based adaptive beamforming are well-known methods within DS and DWS beamforming, respectively. The MV-based adaptive beamforming significantly reduces interferences and provides high-resolution image compared to TFM beamforming, at the cost of high computational complexity, and sensitivity to input statistics for matrix inversion. To address these challenges, recently, iterative MV (IMV) has been proposed to alleviate computational burdens without the need for matrix inversion. The delay-multiply-and-sum (DMAS) beamforming enhances TFM beamforming performance by employing spatial information of the array signals. However, the resulting images remain susceptible to speckle and background noises in all of these beamformers. In this paper, we aim to improve these beamforming methods so that speckle and Gaussian background noise are reduced while preserving the quality of the reflective echoes in ultrasonic images. In the proposed method, a wavelet transform with a novel threshold function is applied to the received signals to initially reduce the noise, followed by the application of the beamformer. Subsequently, the coherence weighting using the denoised signals is derived, and the obtained coherence weighting is then integrated into the beamforming process. Simulation results demonstrate that the proposed method achieves a significant reduction in background noise and speckles of the above beamformer, and particularly reduces background noise and speckles of beamformer up to approximately -27dB while preserving the detection capability of reflective points.
Power systems
Mehdi Bekrani; Mojtaba Heydari; Seyedeh Tahereh Behrooz
Abstract
In this paper, a new adaptive control method is proposed for direct matrix converters. The proposed method uses interval type-2 fuzzy logic integrated with sliding mode control. Employing the sliding mode control in matrix converters leads to an efficient choice of switching combinations and a reliable ...
Read More
In this paper, a new adaptive control method is proposed for direct matrix converters. The proposed method uses interval type-2 fuzzy logic integrated with sliding mode control. Employing the sliding mode control in matrix converters leads to an efficient choice of switching combinations and a reliable reference tracking. The main problem of the sliding mode control is the chattering phenomenon that degrades the controller performance through injecting high-frequency variations in the controller variables. The proposed method incorporates the interval type-2 fuzzy with the sliding mode control to mitigate the chattering problem. The sliding mode switch surface can be adjusted adaptively according to the system state and the proposed fuzzy compensation based on the Lyapunov stability theorem, so that the control system has the characteristics of low chattering effect and appropriate operation quality. Comprehensive evaluations of the waveforms are conducted for the new matrix converter through various simulations. Simulation results verify the effectiveness of the proposed adaptive control method for matrix converter in various conditions, and its superiority in chattering suppression in comparison to the conventional sliding mode control and the boundary layer method.